1. What are all the Quality checkpoints while welding with SS? Welding of SS special compared to CS. Do not mix up CS with SS welding...
1. What are all the Quality checkpoints while welding with SS?
Welding of SS special compared to CS. Do not mix up CS with SS welding. Avoid using the same hand gloves, grinding wheel, tongs, or even the same work area used for CS to avoid Carbon migration on SS. Handle SS carefully. Stake it vertically to avoid walking over it which forms serrations. All the above may lead to corrosion. Use special SS grinding wheel to avoid clogging of grinding wheels. Do not use yellow-oil chalks (sulfur-rich) for writing on SS to avoid corrosion. Check currents as recommended by the manufacturers. Pickling and passivation shall be done after welding when required. There are plenty more.
2. How to check the discoloration while welding?
Use low currents (15 % or less) compared to MS welding. The weld or HAZ should not turn to blue, which means depletion of chromium (reaction with Oxygen to form Cr -Oxides) The weld should be straw / light yellow, white to show non-reaction. Stop the welding if required, to avoid overheating while welding.
3. Purge time calculation?
It is difficult as it depends upon the length of the plate, pipe dia., etc. Purge till you make sure the oxygen is removed fully. Use a burning match stick (easier method) to check the outflow of gas. Any left out oxygen may create oxidation at the root side and is not acceptable.
4. If the thickness of the base material is less than 3mm what are all aspects shall be followed to maintain good welding?
Use Pulsed TIG welding processes as it gives very low heat input compared to normal /continuous weld. Pulsing is good for higher thicknesses also.
5. What is the distance calculation for purging?
Purging could be localized or to the full length of the pipe if required. Purging could be 40 -50 % less to shielding pressure. gas inlet end could be around 50 to 75 mm or so from the weld Cir-seam end if it is a pipe.
6. How to determine the electrical parameter and shielding gas parameters, preheating details for GTAW while preparing proposed WPS for SS and NON-FERROUS MATERIALS?
SS does not require any preheating. The inter-pass temperature could be around 75 to 150 deg.C max. The total heat input should be less or nearer to 1.0 kj /mm. Use stringer runs only. Do not use weave pass to avoid more heat input. The shielding gas pressure could be between 8 -10 -12 LPM. For nonferrous metals, heat input could be around 2.0 kj/mm. Use only DC EN for both SS & MS.
No comments